Make a Los Publication Cover
Material
You will need …
Paper to model
Plain cloth
Chalk seamstress
Step 1
Make a card with the same size of the head model. Cut out two pieces of fabric larger than the model. Pen model for a piece of cloth and plaster with a seamstress, draw a line 2.5 centimeters (seam allowance) the outer edge of the model. Release and repeat for the second linen. Cut along the chalk lines.
Step 2
Cut a strip ofessentially the wedge, the length of the top and two sides, in addition to 2.5 centimeters across. Make a length of pipe with a cloth across the same size flat wedge. Put the right front side of the panel and pin and baste piping along the edges and the top edge, aligning the edges.
Step 3
30 Cut into eight 6 centimeters strips of cloth for the tape. Fold in half lengthwise and cars along the sides open. Turn inside out and iron.
Step 4
Pen wedge plateon the front panel, right side together, so that the syringe between the two pieces of cloth.
Step 5
Two bands of slip between the syringe and the wedge, about one quarter of the way from the bottom of the panel, and three-quarters of the road. The pen is in place. Repeat for the other side. Baste and machine layers together point to a 1.5 cm seam allowance. Place the back right side of the wedge, oil and tires, adjusting the rough edges. Pen bands corresponding place.Baste and machine mesh together and leaving a 1.5 cm seam allowance.
Step 6
Pin, baste and machine in a 2 cm along the bottom edge of the lid. Block any sharp edges to prevent fraying when recycling. Turn right, press and slide overhead. Loop Tie on the side.
Comments