Standard wooden jewelry box – Give your beloved a gift Handcrafted
As a carpenter, you have access to a lot of ways when it comes to gifts. It means much more to your wife or mother when you have a gift for them in your own workshop. One of the most basic carpentry projects that create every rookie champion quilt rack, small shelves, spice racks, wall shelves and decorative wood jewelry boxes, to name a few.
Today we speak of the jewel. This is one of the simplest gifts are madesmall garage workshop.
* Tools and equipment needed is very simple in nature. You need a circular saw, router table and router, orbital sander, finishing Sander (optional) and some small hand tools.
* Supplies needed for this project is the choice of wood, wood glue, oil Danish. tack rags woodworking and was.
The choice of wood is a matter of personal preference, but I would also walnuts, red hearts, canary wood, or purple heart. The reason that I likethese types, because they are easy to implement. All that is necessary to apply a generous coat of Danish oil, let dry and rub with Woodworkers Brilwax was natural. All these forests have their natural color and do not need to lead no.
1. The theme will consist of 6 pieces, the size is determined by the total size of the window. Cut two pieces of top and bottom, two pieces on the sides and two pieces for the ends. Close the top and bottom slightly larger than the desiredfinished piece.
2. Mitra all corners of the sides and end pieces at an angle of 45 degrees.
3. Glue the sides and ends to form an open box and let dry.
4. Cut the top and bottom pieces to fit a small overhang.
5. With both tops and bottoms are in place and allow to dry.
6. Use the orbital sander with rectangular top and bottom, so you have a window, even around.
7. Cut the box in two pieces about 3 / 4 of the way to zero. It gives you an upper andbottom of the jewel.
8. At the top, the noise from an outer lip about 3 / 4 of the way in which a small lip on the inside. Next in the lower part, the noise from a niche within about 1 / 4 of the road and leave a small depression in the low to upper lip received. Sure that the depth is the same on both the top and bottom and look for a good mash together. (* See note below for the opportunity of this step)
9. Onthe top of the window, a border around the top edge of defeat fantasy content. This eliminates fine grain of the top.
10. Bottom margin of fantasy route around the outside bottom edge of the window. Side of a little 'creek, headed for a portion of the lower edge starts and ends about 1 / 2 "to 3 / 4" from the end gun. This will give the appearance of your feet to your inbox.
11. Sand pass on to finish very well on all surfaces inside and outside. Wipe with a tackrags.
12. Flood all parts of the subject with the Danish oil and cattle with papierhanddoeke. Allow to dry.
13. Rub in several layers of Briwax has been working with wood and buff to desired sheen.
* Note: One option is to remove the step # 8 and a ribbon zipper back on them.
How it works reasonably well for this project. If you want you can see the inside of the box applies the feeling of an additional feature. Remember, it is useful if you have a couple of tree of knowledge, when the nextinstructions. There are many ways to a wooden jewelry boxes, so the best advice is to research and study of how one feels the best use for the construction of a project to find. I tried this method for different methods. To decide which router bits for use in decorative work, you can try different pieces, until the excess pieces of wood until you can see what you want.
Comments